Trusted Clean Easy Lift SC Wax & Finish Remover is a super concentrated floor finish stripper. Typical dilution ration is 1 part stripper to 20 parts water, or basically 1 quart for 5 gallons of water. Each quart makes 5¼ gallons of stripper.Talk about a cost saving alternative to most stripping solutions!

Please make sure to read all cautions and directions before using this product. It contains alkaline ingredients normally found in powerful strippers. Quick penetrating agents and liquefying ingredients require that this product be used according to directions, as with all of our cleaning and janitorial products.

We recommend that you pre-test this product on a small area before applying across your entire job. Do not use this product undiluted. Dilute at 1 part stripper to 20 parts water. Use hot water. Mop onto floor and allow to set 3 or 4 minutes. Do not allow stripper to dry on floor. Keep floor wet. Use a rotary floor scrubber or auto scrubber to agitate and loosen your finish. Picking up loosened finish is most effective with a wet vacuum but may also be mopped off the floor. Rinse surface thoroughly with clean water. Use a neutralizer to remove remaining residue after rinsing. Apply a sealer and finish, like our Trusted Clean Seal & Finish in a normal manner.

Attention: On old linoleum, rubber and asphalt floors do not use an over concentration of solution, as bleaching or discoloring may occur. Test a small area using a solution no stronger than 1 part of stripper to 10 parts of water. Adjust concentration to strip effectively without harming floor substrate.

• Floor waxes
• Acrylic, styrene, polymers, co-polymers, oligimers, and metal cross linked finishes
• Acrylic and water based urethane sealers

*Please Note: SDS information available upon request.