Loveshaw® Little David® Double Tamp Label Printer and Applicator

*Please Note: This label applicator formerly had a part # of LOV-LS-800DT.

This Loveshaw Little David double tamp label printer and applicator has a robust industrial design that easily integrates into automatic print/apply labeling applications. The UL listed controls and user friendly touch screen provide a simple, easy operation. The "isolated rewind shut-off" allows threading of labels without turning off the machine. The simplified set up process takes less than 10 minutes to complete. Freight is F.O.B. Shipping Point.

For other options, take a look at our label applicators category.

Features

• Prints and applies a corner wrap, dual tamp, front-side-back only label
• Can apply labels to bottom edge of product
• Up to 16 inches/second dispense speed based on printer selection
• Universal yoke stand is standard

Machine Dimensions:

• Length: 17.27" (25"-31" depending on length of arm)
• Width: 46.50" (width of stand)
• Height: 24 3/16 inches
• Weight: 100 pounds

Dual Tamp Print & Apply Labeler Requirements:

• Width: 1 inch - 5 1/4 inches
• Length: 1/2 inch - 14 inches
• Roll Outside Diameter: 11 7/8 inches & optional
• Core Diameter: 3 inch & 4 inch
• Finish: Pressure sensitive die cut with 1/8 inch gap
• Air: 60 PSI at .5 CFM while dispensing
• Electrical: 115-230 volts; 50/60 cycle; 5 Amps

Available Options:

• 305 dpi print resolution
• "H" floor mounting stand
• Direct thermal
• Low media signal alarm beacon
• Printer selection (Sato, Zebra, Datamax)
• Label generation software available
• Left-hand feed printer
• 15 7/8 inch roll diameter
• 6 inch core diameter